The Real -TU Phono Preamplifier.

Flagship grade Phono preamplifier.

The main stage with external power supply , 2 unit design.

The Real use T-LCR type RIAA EQ design, the T-LCR Type is best method for revive RIAA EQ, also is highest cost design.

It uses 12AX7 ,WE396A  with Tango line output transformer for input stage, special made T-LCR type RIAA EQ , WE417A with Tango  line output transformer output stage( with XLR and RCA output).

The The Real 's application of a highly efficient solid-state voltage regulator with 6X4 Tube for current regulator and tow Tango choke in the HVB+ power supply . Also it use the external power supply get highest S/N.

The MC step up transformer use Hasimoto ( made in Japan ) and Jensen ( made in USA )


rphotu2.jpg (546126 個位元組) rphotu3.jpg (406363 個位元組) 
 rphotu5.jpg (416517 個位元組) rphotu6.jpg (419848 個位元組) rphotu4.jpg (406605 個位元組) rphotu7.jpg (405235 個位元組)

rphotu8.jpg (326639 個位元組) rphotu9.jpg (357959 個位元組) rphotu10.jpg (370728 個位元組) rphotu11.jpg (393432 個位元組)

rphotu12.jpg (361140 個位元組) rphotu13.jpg (420333 個位元組) rphotu16.jpg (398060 個位元組) rphotu14.jpg (318557 個位元組) rphotu15.jpg (430357 個位元組) 


Power Supply : Power On/Of .

Main Unit : 
Output XLR/RCA, Phase Normal / Inverse , Input MC/MM , MC Gain High/Low , MC Input 1,2,. 

Output :  1 pair Main XLR , 1pair Main RCA.

Input : MC1 input , MC2 input, MM input ( all RCA ).

Output Impedance :  
600 ohms ( XLR and RCA same ) , 600 ohms minimum load.

Frequency Response: +/- 0. 15dB 20Hz to 20KHz , RIAA equalized , ( -3db at 75khz )

Input Impedance: 

MC1 use Jensen step-up transformer.
MC2 use Hasimoto step-up transformer.

MC1 low gain: 
DC Impedance 5 ohm ( for 4 ~ 60ohm internal DC Impedance of MC cartridge )
Zi  Impedance 700 ohm ( for load Impedance over 400 ohm MC cartridge )

MC1 low gain: 
DC Impedance 2.5ohm ( for 1 ~ 40hm internal DC Impedance of MC cartridge )
Zi Impedance 310 ohm ( for load Impedance over 100 ohm MC cartridge )

MC2 low gain: 
DC Impedance 12ohm ( for 7 ~ 40ohm internal DCImpedance of MC cartridge )
Zi Impedance 200 ohm ( for load Impedance over 100 ohm MC cartridge )

MC2 high gain: 
DC Impedance 3ohm ( for 2 ~ 7ohm internal DC Impedance of MC cartridge )
Zi Impedance 50 ohm ( for load Impedance over 20 ohm MC cartridge )

MM is 47K / 100P ( the capacitance impedance can change by module )

MM gain 41dB, 
MC1 low gain 58.5dB, MC1 high gain 62dB
MC2 low gain 64.5dB, MC1 high gain 70.5dB

Noise: MM 93.5dB (shorted input) , MC 93dB (shorted input).
signal-to-noise ratio, below 1 Volts RMS output,  A weighted

Phase Mode : Normal / Inverse.

Max input : MM 80mV, MC 8mV

Distortion: Less than .04% at 0.5V RMS 1kHz output.

Tube Compliment : 12AX7 x2, WE396A x2,  WE417A x2 , 6X4 x1.

Main unit , 455mm x 350mm x 200mm (W x D x H) 
Power Supply ,455mm x 350mm x 180mm (W x D x H)

Total Weight: 30kg

Power Source: 110-127/220 - 240V,50/60Hz


Actual Price: HK$63000

Room1308, 13/F,BLK C,.  
Kai Tak FTY BLDG.   
99-101 King Fuk ST,.   
San Po Kong,   KLN,.
Hong Kong
E-mail : 
WhatsApp: 93440168   
facebook :